SketchUp plugin · v0.1.0
Prefab Studio
Without Working Out Steel and Quantities by Hand: Drag the Slider, the Prefab and Its Take-Off Update Instantly
When the client says “make it a bit wider”, they see the new numbers right there. Every slider rebuilds the frame, trusses, purlins, cladding and foundation live — and recounts steel kg, panel m², screws and M16 anchors as you drag.
How much time does it save?
Re-modelling the frame, then recounting the takeoff
Drag the width slider; the takeoff follows
Three Sliders, a Ready Building
Width, length, height. The stud grid, trusses, purlins, panels and slab rebuild themselves at every drag — 3.6–15 m by 4.8–24 m. No re-modelling the frame.
The Span Picks the Truss
Fink under 6.5 m, Pratt to 8 m, Howe above — and past 9.5 m a prestressed C40 precast truss. Section and bolts follow the load, so you never have to remember which truss goes where.
A Take-Off That Never Falls Behind
Steel kg, panel m², roof screws, M16 anchors at 1.35 m, truss count — recomputed on every drag. Export the lot as GLB. No recounting before you quote.
Features
- 3.6-15 m x 4.8-24 m
- 3 truss types, auto-picked
- Live steel kg + panel m²
Compatibility
- Desktop browser - WebGPU preferred, automatic WebGL fallback shown as a viewport badge
- GLB (glTF binary) is the only export in 0.1.0
- Not a SketchUp plugin - the project contains no Ruby and no .skp code
Current version, pricing and purchase live on the product's own page.
SketchUp articles
Related posts from the archive — written in Turkish.
- Sadece Ölçüyü Gir, Gerisini Mutfak Programı Halletsin
- Kertik, Kiriş Sorun Değil!
- 1 Dakikada Mutfak Tasarla, Üretime Geç
- Sürükle Bırak, Dolabın Hazır